2750mAh 2 In 1 Waterproof Phone Case External Back Up Battery Charger Case For iPhone 6 6s
(0 Reviews) Sold: 2
2 In 1 Waterproof Phone Case 2750mAh External Back Up Battery Charger Case For iPhone 6 6s 4.7 Inch
1.Waterproof battery case for your iphone6/6s, no more worries about your phone when go to the harsh place.
2.With a built-in 2750MAh battery, LED indicator show the current battery status.
3.Ports and buttons cover is made of rubber or seal, easy to access and preventing leakage.
Material: Poly carbonate, plastic and rubber
Battery type: Li-polymer
Battery capacity: 2750MAh
Fit for: iPhone 6/6s
1 x Battery Case
1 x Earphone Extension Wire
1 x Cleaning Cloth
1 x Hand Strap
1 x Tool
1 x User Manual
Check that the o-ring is installed correctly. Make sure that it is free of dust, dirt, hair and other debris. (If the o-ring is not clean, remove it and rinse in warm water, then give it a quick shake to remove excess water before immediately reinstalling.
Check that your phone case is good-to-go by putting it through a water test. This test checks that all the seals and case’s function are working properly.
A.Check seals are clean and in-place on the front case.
B.Align the front and rear cases.
C.With the back facing down, press firmly all around the case to ensure seals are completely closed all the way around.
D.Fully submerge case under water weighing down with a cup for 30 minutes.
E.After 30 minutes, remove from water and check that case is dry inside.
Note: remove any phone case prior to waterproof case installation.
A.Thoroughly clean iPhone 6 with included cloth.
B.Check seals are clean and in-place on the front case, check if there is gap or broken on slot of the o-ring seal,if there is gap replace the front cover in time.
C.Align insert the mobile phone charge port and the power bank plug.
D.Insert the iphone6 into the rear of the case, aligning the front rear.
E.Phone shell upper and lower lid firmly pressed, make sure all parts are fastened around the shell, sealed.
F.Press firmly all around the case to ensure seals are completely closed all the way around.
4. The charging operation:
After installation is complete, press 3 seconds to turn on or turn off the power.
1.Twist open with coin or other tools.
2.Open the front cover.
3.Lift the top of the phone gently, then take out slowly.
1.Keep seals clean: always ensure all seals around and the charge port door, headphone cover and o-ring are free of dust, fibers and debris before closing case.
2.Regular water test: perform water test without your phone, at regular intervals and after major imparts.
3.Rinse with freshwater after use: Rinse case thoroughly with fresh water after exposure to chemicals including soap, detergents, and chlorine.
4.Check seals after major impacts: after major drops or impacts, inset case for any damage and ensure all seams are closed.
5.If a major impact occurs:
A. Check that front and back of case has not come apart at any point and all seals are tightly closed;
B. Check headphone jack cover is still screwed in.
6. When removing the mobile phone, shell angle can not be more than 22 degrees.